Suzuki Baleno Manual page 679

1. Torque converter
2. Flange nut
3. Transmission case housing
4. Cup
57) Install oil pipes.
i) If oil outlet pipe has been removed or replaced, tighten it
with union bolt with new gaskets to specified torque.
Tightening Torque
(I): 22 N·m (2.2 kg-m, 16.0 lb-ft)
ii) Clamp pipes with oil pipe plate through rubber tubes.
Tightening Torque for plate bolts
8 mm: 13 N·m (1.3 kg-m, 9.5 lb-ft)
6 mm: 5.5 N·m (0.55 kg-m, 4.0 lb-ft)
58) Install oil filler tube with O ring.
Insert oil filler tube in case as far as its flange and tighten with
bolt.
NOTE:
Check to make sure that oil filler tube O ring is in good
condition.
1. Union bolt
2. Oil outlet pipe
Tightening Torque
3. Oil filler tube
(m): 5.5 N·m (0.55 kg-m, 4.0 lb-ft)
4. Bolt
59) Install engine mounting LH bracket.
Tighten bolts to specification. (Refer to "ENGINE ASSEMBLY"
in Section 6A1.)
Tightening Torque for bracket bolts
55 N·m (5.5 kg-m, 40.0 lb-ft)
60) Install torque converter to input shaft.
i) Install torque converter, using care not to damage oil seal
of oil pump.
ii) After installing torque converter, check to make sure that
distance "e" is within specification.
Distance "e": More than 21.4 mm (0.85 in.)
iii) Check torque converter for smooth rotation.
iv) Apply grease around cup at the center of torque converter.
"C": SUZUKI SUPER GREASE A, 99000-25010
AUTOMATIC TRANSMISSION (3 A/T) 7B-109
CAUTION:
D Before installing converter, make sure that its
pump hub portion is free from nicks, burrs or
damage which may cause oil seal to leak.
D Be very careful not to drop converter on oil
pump gear. Damage in gear, should it occur,
may cause a critical trouble.