Suzuki Baleno Manual page 883

1. No.1 control rod
2. No.2 control rod
1. Rear drive shaft
2. Rear differential
1. Propeller shaft flange bolt
2. Rear differential mounting bolts
3. Propeller shaft
4. Jack
UNIT REPAIR OVERHAUL
DISMOUNTING
1) Hoist vehicle and remove wheels.
2) Drain oil from rear differential. (Refer to "OIL CHANGE" in this
3) Remove parking brake cable from trailing rod.
4) If vehicle is equipped with ABS, remove wheel speed sensor
5) Remove No.1 and No.2 control rod outer bolt.
6) Remove trailing rod rear bolt.
3. Trailing rod
4. Parking brake cable
5. Wheel speed sensor
(equipped with ABS)
7) Remove rear drive shafts from rear differential.
8) Place jack so that differential assembly will not tilt.
9) Remove 4 propeller shaft flange bolts from rear differential,
10) Remove 6 rear differential mounting bolts.
section.)
harness from No.2 control rod.
and then pull out propeller shaft from rear differential.
REAR DIFFERENTIAL 7F-5