Suzuki Baleno Manual page 767

1. Drive shaft joint
2. Screwdriver
1. Engine rear mounting
2. Engine rear
mounting
bracket
1. Engine LH mounting
2. Transmission
1. Engine LH mounting
2. Engine mounting LH bracket
3. Transmission
21) By using large size screwdriver, pull out drive shaft joints at dif-
ferential side so as to release snap ring fitting.
22) Disconnect stabilizer joints from suspension arms on both
sides.
23) Remove ball stud bolts and nuts from both knuckles and de-
tach suspension arms and then pull out both drive shaft joints
from differential.
24) Remove engine rear mounting and its bracket.
25) Remove engine-to-transmission bolt and nut.
26) Support transmission with transmission jack.
27) Remove bolts from engine LH mounting.
28) Remove transmission with torque converter from engine
compartment.
WARNING:
Be sure to keep transmission with torque converter
horizontal or facing up through out the work. Should
it be tilted with torque converter down, converter
may fall off and cause personal injury.
29) Remove engine LH mounting and its bracket from transmis-
sion case.
AUTOMATIC TRANSMISSION 7B1-83