Clutch Cable - Suzuki Baleno Manual

1. Dash panel
2. Clutch cable outer
bolt

CLUTCH CABLE

REMOVAL
1) Remove clutch cable joint nut and disconnect joint pin from in-
ner cable.
2) Remove 2 bolts at dash panel, unhook cable end from pedal
top, and then take out cable.
INSPECTION
Inspect clutch cable and replace it if any of following conditions ex-
ists.
D Excessive cable friction.
D Frayed cable.
D Bent or kinked cable.
D Broken boots.
D Worn end.
INSTALLATION
1) Apply grease to cable end hook and also joint pin before instal-
ling cable.
2) Hook cable end with pedal, then join inner cable with joint pin
in release arm.
3) Fasten cable with 2 bolts to dash panel.
"A": Sealant 99000-31090
Tightening Torque
(a): 11 N·m (1.1 kg-m, 8.0 lb-ft)
4) Screw in joint nut and adjust free travel of pedal to specification
by turning nut.
5) Check clutch for proper function with engine running.
CLUTCH (CABLE TYPE) 7C-5