Member-Vlan - Dell Z9500 Command Reference Manual

member-vlan

Specify the member VLAN identification numbers.
Syntax
member-vlan {vlan-range}
To return to the default, use the no member-vlan [vlan-range] command.
Parameters
vlan-range
Defaults none
Command CONFIGURATION (conf-frrp)
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.7(0.0)
9.0.2.0
8.3.11.1
8.3.7.0
8.2.1.0
7.4.1.0
mode
Set the Master or Transit mode of the ring.
Syntax
mode {master | transit}
To reset the mode, use the no mode {master | transit} command.
786
Enter the member VLANs using VLAN IDs (separated by
commas), a range of VLAN IDs (separated by a hyphen), a
single VLAN ID, or a combination. For example: VLAN IDs
(comma-separated): 3, 4, 6. Range (hyphen-separated):
5-10. Combination: 3, 4, 5-10, 8.
Description
Introduced on the S6000–ON.
Introduced on the S6000.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the C-Series.
Introduced.
Force10 Resilient Ring Protocol (FRRP)