Dell Z9500 Command Reference Manual page 785

Hide thumbs Also See for Z9500:

Table of Contents

control-vlan

CONFIGURATION (conf-frrp)

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

This command causes the Ring Manager to take ownership of the two ports after

IFM validates the configuration. Ownership is relinquished for a port only when the

interface does not play a part in any control VLAN, that is, the interface does not

belong to any ring.

Force10 Resilient Ring Protocol (FRRP)

Enter the keyword secondary to configure the secondary

interface then one of the following interfaces and slot/port

information:

For a 10-Gigabit Ethernet interface, enter the keyword

TenGigabitEthernet then the slot/port information.

For a 40-Gigabit Ethernet interface, enter the keyword

fortyGigE then the slot/port information.

For a port channel interface, enter the keywords port-

channel then a number.

Enter the keyword control-vlan then the VLAN ID. The

range is from 1 to 4094.

Introduced on the S6000–ON.

Introduced on the S6000.

Introduced on the S4820T.

Introduced on the Z9000.

Introduced on the S4810.

Introduced on the C-Series.

— displays the Resilient Ring Protocol configuration information.