Dcb-Policy Output - Dell MXL 10GbE Reference Manual

Version 8.3.16.1
Usage The dcb-policy input stack-unit all command overwrites any previous
Information
dcb-policy input stack-unit stack-unit-id configurations. Similarly, a
dcb-policy input stack-unit stack-unit-id command overwrites any
previous dcb-policy input stack-unit all configuration.
Related dcb-policy output stack-unit stack-ports all
Commands policy.

dcb-policy output

Apply the output policy with the ETS configuration to an egress interface.
Syntax
dcb-policy output policy-name
To delete the output policy, use the no dcb-policy output command.
Parameters
policy-name
Defaults none
Command INTERFACE
Modes
Command
Version 9.2(0.0)
History
Version 8.3.16.1
Usage
When you apply an ETS output policy to on interface, ETS-configured scheduling
Information
and bandwidth allocation take precedence over any configured settings in QoS
output policies.
To remove an ETS output policy from an interface, use the no dcb-policy
output policy-name command. ETS is enabled by default with the default ETS
configuration applied (all dot1p priorities in the same group with equal bandwidth
allocation).
422
Introduced on the MXL 10/40GbE Switch IO Module.
NOTE: Please note that Dell Networking does not recommended to use this
command as it has been deprecated in the current 9.4.(0.0) release. A warning
message appears when you try to run this command indicating that you have
to use the dcb-map commands in the future.
Enter the output policy name.
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Introduced on the MXL 10/40GbE Switch IO Module.
NOTE: Please note that Dell Networking does not recommended to use this
command as it has been deprecated in the current 9.4(0.0) release. A warning
message appears when you try to run this command indicating that you have
to use the dcb-map commands in the future.
— applies the specified DCB output
Data Center Bridging (DCB)