Mac-Address-Table Static (For Multicast Mac Address) - Dell S6100 Configuration Manual

Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version
9.3(0.0)
Usage Information For multicast mode of NLB, to associate an IP address with a multicast MAC address in the switch, use address
resolution protocol (ARP) by entering the arp ip-address multicast-mac-address command in Global
configuration mode. This setting causes the multicast MAC address to be mapped to the cluster IP address for
NLB mode of operation of the switch.
Related Commands
•
•
mac-address-table static (for Multicast MAC
Address)
For multicast mode of network load balancing (NLB), configure a static multicast MAC address, associate the multicast MAC address with
the VLAN used to switch Layer 2 multicast traffic, and add output ports that will receive multicast streams on the VLAN. To delete a
configured static multicast MAC address from the MAC address table on the router, enter the no mac-address-table static
multicast-mac-address command.
Syntax mac-address-table static multicast-mac-address multicast vlan vlan-id range-
output {single-interface | interface-list | interface-range}
To remove a MAC address, use the no mac-address-table static multicast-mac-address
output interface vlan vlan-id command.
Parameters
multicast-mac-
address
multicast
output interface
Description
Added support for association of an IP address with multicast MAC address on the S4810,
S4820T, S6000, and Z9000 platforms.
clear arp-cache — clear dynamic ARP entries from the ARP table.
show arp — display the ARP table.
Enter the 48-bit hexadecimal address in nn:nn:nn:nn:nn:nn format.
Enter a vlan port to where L2 multicast MAC traffic is forwarded.
NOTE:
without IGMP protocols.
For a multicast MAC address, enter the keyword output then one of the following
interfaces for which traffic is forwarded:
• For a Port Channel interface, enter the keywords port-channel then a number.
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then
the stack/slot/port/subport information.
• For a 25-Gigabit Ethernet interface, enter the keyword twentyFiveGigE then the
stack/slot/port/subport information.
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the stack/
slot/port[/subport] information.
• For a 50-Gigabit Ethernet interface, enter the keyword fiftyGigE then the stack/
slot/port/subport information.
Use this option if you want multicast functionality in an L2 VLAN
Microsoft Network Load Balancing 981