Dcb-Input - Dell MXL 10GbE Reference Manual

To disable DCB, use the no dcb enable command.
Defaults none
Command CONFIGURATION
Modes
Command
Version 9.2(0.0)
History
Version 8.3.16.1
Usage DCB is not supported if you enable link-level flow control on one or more
Information
interfaces.

dcb-input

To apply pause or flow control for specified priorities using a configure delay time, create a DCB input
policy.
Syntax
dcb-input policy-name
To delete the DCB input policy, use the no dcb-input command.
Parameters
policy-name
Defaults none
Command CONFIGURATION
Modes
Command
Version 9.2(0.0)
History
Version 8.3.16.1
Usage
As soon as you apply a DCB policy with PFC enabled on an interface, DCBx starts
Information
exchanging information with PFC-enabled peers. The IEEE802.1Qbb, CEE, and CIN
versions of PFC TLV are supported. DCBx also validates PFC configurations
received in TLVs from peer devices.
By applying a DCB input policy with PFC enabled, you enable PFC operation on
ingress port traffic. To achieve complete lossless handling of traffic, also enable
PFC on all DCB egress ports or configure the dot1p priority-queue assignment of
PFC priorities to lossless queues (refer to pfc no-drop queues).
To remove a DCB input policy, including the PFC configuration it contains, enter
the no dcb-input policy-name command in Interface Configuration mode.
Data Center Bridging (DCB)
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Introduced on the MXL 10/40GbE Switch IO Module.
Maximum: 32 alphanumeric characters.
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Introduced on the MXL 10/40GbE Switch IO Module.
417