Dcb-Policy Output Stack-Unit Stack-Ports All - Dell MXL 10GbE Reference Manual

Related dcb-output
Commands

dcb-policy output stack-unit stack-ports all

Apply the specified DCB output policy on all ports of the switch stack or a single stacked switch.
Syntax
dcb-policy output stack-unit {all | stack-unit-id} stack-ports
all dcb-output-policy-name
To remove all DCB output policies applied to the stacked ports, use the no dcb-
policy output stack-unit all command.
To remove only the DCB output policies applied to the specified switch, use the no
dcb-policy output stack-unit command.
Parameters
stack-unit-id
dcb-output-
policy-name
Defaults none
Command CONFIGURATION
Modes
Command
Version 9.2(0.0)
History
Version 8.3.16.1
Usage
The dcb-policy output stack-unit all command overwrites any previous
Information
dcb-policy output stack-unit stack-unit-id configurations. Similarly, a
dcb-policy output stack-unit stack-unit-id command overwrites any
previous dcb-policy output stack-unit all configuration.
You can apply a DCB output policy with ETS configuration to all stacked ports in a
switch stack or an individual stacked switch. You can apply different DCB output
policies to different stack units.
Related dcb-policy input stack-unit stack-ports all
Commands policy.
Data Center Bridging (DCB)
— creates a DCB output policy.
Enter the stack unit identification.
Enter the policy name for the DCB output policy.
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Introduced on the MXL 10/40GbE Switch IO Module.
NOTE: Please note that Dell Networking does not recommended to use this
command as it has been deprecated in the current 9.4.(0.0) release. A warning
message appears when you try to run this command indicating that you have
to use the dcb-map commands in the future.
— applies the specified DCB input
423