Ip Msdp Sa-Limit - Dell Z9500 Reference Manual

Version
9.5(0.1)
8.3.19.0
8.3.11.1
8.3.7.0
7.7.1.0

ip msdp sa-limit

Configure the upper limit of source-active (SA) entries in SA-cache.
Z9500
Syntax
ip msdp sa-limit number
To return to the default, use the no ip msdp sa-limit number command.
Parameters
number
Defaults 50000
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.5(0.1)
8.3.19.0
8.3.11.1
8.3.7.0
7.5.1.0
Usage The system counts the SA messages originated by itself and those messages
Information received from the MSDP peers. When the total SA messages reach this limit, the
subsequent SA messages are dropped (even if they pass RPF checking and policy
checking).
If the total number of SA messages is already larger than the limit when this
command is applied, those SA messages that are already in the system continue to
1192
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series.
Enter the maximum number of SA entries in SA-cache. The
range is from 0 to 40000.
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series.
Multicast Source Discovery Protocol (MSDP)