Ip Msdp Sa-Limit - Dell S4810 Reference Manual

Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 7.7.1.0

ip msdp sa-limit

Configure the upper limit of source-active (SA) entries in SA-cache.
S4810
Syntax
ip msdp sa-limit number
To return to the default, use the no ip msdp sa-limit number command.
Parameters
number
Defaults 50000
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 7.5.1.0
Usage Dell Networking OS counts the SA messages originated by itself and those
Information messages received from the MSDP peers. When the total SA messages reach this
limit, the subsequent SA messages are dropped (even if they pass RPF checking and
policy checking).
If the total number of SA messages is already larger than the limit when this
command is applied, those SA messages that are already in Dell Networking OS
1120
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series.
Enter the maximum number of SA entries in SA-cache. The
range is from 0 to 40000.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series.
Multicast Source Discovery Protocol (MSDP)