Debug Ip Bgp Ipv6 Unicast Soft-Reconfiguration - Dell MXL 10GbE Reference Manual

debug ip bgp ipv6 unicast soft-reconfiguration

Enable soft-reconfiguration debugging for IPv6 unicast routes.
Syntax
debug ip bgp [ipv4-address | ipv6-address | peer-group-name]
ipv6 unicast soft-reconfiguration
To disable debugging, use the no debug ip bgp [ipv4-address | ipv6-
address | peer-group-name] ipv6 unicast soft-reconfiguration
command.
Parameters
ipv4-address |
ipv6-address
peer-group-
name
ipv6 unicast
Defaults Disabled.
Command EXEC Privilege
Modes
Command
Version 9.2(0.0)
History
Usage
This command turns on BGP soft-reconfiguration inbound debugging for IPv6
Information
unicast routes. If no neighbor is specified, debug is turned on for all neighbors.
ipv6 prefix-list
Configure an IPv6 prefix list.
Syntax
ipv6 prefix-list prefix-list name
Parameters
prefix-list name
Defaults none
Command CONFIGURATION
Modes
Command
Version 9.2(0.0)
History
400
Enter the IP address of the neighbor on which you want to
enable soft-reconfiguration debugging.
Enter the name of the peer group on which you want to
enable soft-reconfiguration debugging.
Debug soft reconfiguration for IPv6 unicast routes.
Introduced on the MXL 10/40GbE Switch IO Module.
Enter the name of the prefix list.
NOTE: There is a 140-character limit for prefix list
names.
Introduced on the MXL 10/40GbE Switch IO Module.
Border Gateway Protocol IPv4 (BGPv4)