Dell MXL 10GbE Reference Manual page 405

fcoeacl
number
Iscsioptacl
number
vrfv4acl
number
l2acl number
ipv4acl number
ipv6acl
number,
ipv4qos
number l2qos
number, l2pt
number
ipmacacl
number
ecfmacl
number [vman-
qos | vman--
qos-dual
number |
vman-qos-
dual-fp
number]
ipv4pbr
number
Command CONFIGURATION
Modes
Command
Version 9.4.
History
(0.0)
Version 8.3.16.1
Usage
Save the new CAM settings to the startup-config (write-mem or copy run
Information
start) then reload the system for the new settings to take effect.
The total amount of space allowed is 16 FP Blocks. System flow requires three
blocks; these blocks cannot be reallocated. The ipv4acl profile range is from 1 to
4.
When configuring space for IPv6 ACLs, the total number of Blocks must equal 13.
Content Addressable Memory (CAM)
Enter the keyword fcoeacl and then the number of FP
blocks for FCOE ACL. The range is from 0 to 6.
Enter the keyword iscsioptacl and then the number of FP
blocks for iSCSI optimization ACL. The range is from 0 to 2.
Enter the keyword vrfv4acl and then the number of FP
blocks for VRF IPv4 ACL. The range is from 0 to 2.
NOTE: Use this attribute to specify the number of VRF
ACL groups. The total number of VRF ACL groups should
not exceed 13. You can assign only one VRF ACL group
with an odd numbered value.
Allocate space to each CAM region.
Enter the CAM profile name then the amount of CAM space
to be allotted. The total space allocated must equal 13. The
range for ipv4acl is from 1 to 4. The ipv6acl range must be a
factor of 2.
The total space allocated must equal 13.
The range for ipv4acl is 1 to 4.
The ipv6acl range must be a factor of 2.
The vman-qos-dual-fp number must be entered as a
multiple of 4.
Added support for PBR.
Introduced on the MXL 10/40GbE Switch IO Module.
405