To do...
Enable proxy checking function
globally
Enable proxy
checking for a
port/specified
ports
The proxy checking function needs the cooperation of H3C's 802.1x client (iNode) program.
The proxy checking function depends on the online user handshaking function. To enable the
proxy detecting function, you need to enable the online user handshaking function first.
The configuration listed in the above table takes effect only when it is performed on CAMS as well
as on the switch. In addition, the client version checking function needs to be enabled on the switch
too (by using the dot1x version-check command).
Configuring Client Version Checking
Follow these steps to configure client version checking:
To do...
Enter system view
Enable
802.1x client
version
checking
Set the maximum number
of retires to send version
checking request packets
Set the client version
checking period timer
dot1x supp-proxy-check
{ logoff | trap }
dot1x supp-proxy-check
In system
{ logoff | trap } [ interface
view
interface-list ]
interface interface-type
interface-number
In port view
dot1x supp-proxy-check
{ logoff | trap }
quit
Use the command...
system-view
In system
dot1x version-check [ interface
view
interface-list ]
interface interface-type
interface-number
In port
view
dot1x version-check
quit
dot1x retry-version-max
max-retry-version-value
dot1x timer ver-period
ver-period-value
Use the command...
1-17
Remarks
Required
By default, the 802.1x proxy
checking function is globally
disabled.
Required
By default, the 802.1x proxy
checking is disabled on a port.
Remarks
—
Required
By default, 802.1x client version
checking is disabled on a port.
Optional
By default, the maximum number
of retires to send version checking
request packets is 3.
Optional
By default, the timer is set to 30
seconds.