Configuring Client Version Checking - 3Com WX3000 Series Operation Manual

To do...
Enable proxy
checking for a
port/specified
ports
The proxy checking function needs the cooperation of an iNode client program.
The proxy checking function depends on the online user handshaking function. To enable the
proxy detecting function, you need to enable the online user handshaking function first.
The configuration listed in the table above takes effect only when it is performed on iMC as well as
on the device. In addition, the client version checking function needs to be enabled on the device
too (by using the dot1x version-check command).

Configuring Client Version Checking

Follow these steps to configure client version checking:
To do...
Enter system view
Enable
iNode client
version
checking
Set the maximum number of
retires to send version
checking request packets
Set the client version checking
period timer
Use the command...
dot1x supp-proxy-check
In system
{ logoff | trap } [ interface
view
interface-list ]
interface interface-type
interface-number
In port view
dot1x supp-proxy-check
{ logoff | trap }
quit
system-view
dot1x version-check [ interface
In system view
interface-list ]
interface interface-type
interface-number
In port view
dot1x version-check
quit
dot1x retry-version-max
max-retry-version-value
dot1x timer ver-period
ver-period-value
Use the command...
1-16
Remarks
Required
By default, the 802.1x proxy
checking is disabled on a port.
Remarks
—
Required
By default, iNode client
version checking is disabled
on a port.
Optional
By default, the maximum
number of retires to send
version checking request
packets is 3.
Optional
By default, the timer is set to
30 seconds.