Suzuki Baleno Manual page 1117

1. Connector for contact coil and driver air bag (inflator)
module (Located near the base of the steering column)
2. Connector for driver air bag (inflator) module or connec-
tor for driver and passenger seat belt pretensioners
3. Connector for passenger air bag (inflator) module
4. "BASE OF COLUMN"
5. "STEERING WHEEL"
6. "PASSENGER INFLATOR"
Air Bag Driver/Passenger Load Tool
This tool is used only when called for in this section. It is used as
a diagnostic aid and safety device to prevent inadvertent air bag
(inflator) module deployment and seat belt pretensioner activation.
The load tool has three connectors attached to its case are electri-
cally functional and serve as resistive load substitutions.
No more than two connectors are used at any time.
One of connectors ("STEERING WHEEL") is used to substitute the
load of the following.
D driver air bag (inflator) module when it is connected at the top of
the column to the contact coil assembly.
D driver and passenger seat belt pretensioner when it is con-
nected to air bag harness connector for driver and passenger
seat belt pretensioner.
Special Tool
(A): 09932-75010
Another connector ("BASE OF COLUMN") is used to substitute the
load of the driver air bag (inflator) module and the contact coil as-
sembly when it is connected at the base of the column to the air bag
wire harness.
The third connector ("PASSENGER INFLATOR") is used to substi-
tute the load of the passenger air bag (inflator) module when it is
connected to the air bag harness connector for passenger air bag
(inflator) module.
By substituting the resistance of the load tool when called for, a de-
termination can be made as to whether an inflator circuit compo-
nent is causing system malfunction and which component is
causing the malfunction.
The load tool should be used only when specifically called for in the
diagnostic procedures.
AIR BAG SYSTEM 9J-17