Suzuki Baleno Manual page 1125

TABLE A – "AIR BAG" WARNING LAMP COMES "ON" STEADY (Page 2 of 2)
STEP
1 1) Ignition switch OFF.
2) Remove and inspect "AIR BAG" fuse.
Is fuse good?
2 1) Disconnect SDM.
2) Check proper connection to SDM at terminal
"A16".
3) If OK then check voltage between "Al6" termi-
nal of SDM connector and body ground with
ignition switch ON.
Is it 8V or more?
3 1) Disconnect 13p connector from combination
meter, referring to Section 8.
2) Check resistance between "A5" terminal of
SDM connector and body ground.
Is resistance 1 kW or more?
Fig. for STEP 2
NOTE:
Upon completion of inspection and repair work, perform the following procedure.
1) Reconnect all air bag system components, ensure all components are properly mounted.
2) Repeat "AIR BAG DIAGNOSTIC SYSTEM CHECK FLOW TABLE" to confirm that the trouble has been
corrected.
ACTION
Special Tool
(A): 09932-76010
YES
Go to Step 2.
Go to Step 3.
Substitute a known-
good SDM and re-
check.
Fig. for STEP 3
AIR BAG SYSTEM 9J-25
NO
"Bl/R" wire short to ground.
After repair, replace "AIR
BAG" fuse.
"Bl/R" wire (between "AIR
BAG" fuse and SDM connec-
tor) open
"Bl" wire (between combina-
tion meter and SDM connec-
tor) short to ground
Special Tool
(A): 09932-76010