Suzuki Baleno Manual page 1126

9J-26 AIR BAG SYSTEM
TABLE B – "AIR BAG" WARNING LAMP DOES NOT COME "ON" (Page 1 of 2)
: Air bag harness
1. From main fuse
2. Ignition switch
3. "IG" fuse in J/B
CAUTION:
D When measurements are requested in this table use specified digital multi meter with correct ter-
minal adapter from special tool (Connector test adapter kit).
D When a check for proper connection is requested refer to "INTERMITTENT AND POOR CONNEC-
TION" in Section 0A.
D When an open in air bag wire harness, damaged wire harness, connector or terminal is found, re-
place wire harness, connectors and terminals as an assembly.
TABLE TEST DESCRIPTION
STEP 1: Check combination meter power feed circuit.
STEP 2: Check electrical connection check mechanism in SDM connector.
STEP 3: Check "AIR BAG" warning lamp circuit.
STEP 4: Check open in "AIR BAG" warning lamp circuit.
STEP 5: Check short from "AIR BAG" warning lamp circuit to power circuit.
STEP 6: Check "AIR BAG" bulb.
4. "AIR BAG" fuse in J/B
5. "AIR BAG" warning lamp in combination meter
6. Connection detection pin
7. SDM
7-1. "AIR BAG" warning lamp driver circuit