Suzuki Baleno Manual page 1139

CODE 19 – PASSENGER AIR BAG INITIATOR CIRCUIT SHORT TO POWER CIRCUIT
(Page 2 of 2)
NOTE:
Before executing items in this table, be sure to perform "AIR BAG DIAGNOSTIC CHECK FLOW TABLE".
STEP
1 1) With ignition switch OFF, disconnect passen-
ger air bag (inflator) module connector be-
hind the glove box.
2) Check proper connection to passenger air
bag (inflator) module at terminals in "B" con-
nector.
3) If OK then connect special tool (B) to passen-
ger air bag (inflator) module connector dis-
connected at the Step 1.
With ignition switch ON, is DTC 19 current?
2 1) With ignition switch OFF, disconnect special
tool (B) and SDM.
2) Measure voltage from "A3" terminal to body
ground.
With ignition switch ON, is voltage 1 V or less?
Fig. for STEP 1 and 2
Special Tool
(B): 09932-75010
NOTE:
Upon completion of inspection and repair work, perform the following procedure.
1) Reconnect all air bag system components, ensure all components are properly mounted.
2) Clear diagnostic trouble codes (Refer to "DIAGNOSTIC TROUBLE CODE (DTC) CLEARANCE"), if any.
3) Repeat "AIR BAG DIAGNOSTIC SYSTEM CHECK FLOW TABLE" to confirm that the trouble has been
corrected.
ACTION
1. "PASSENGER INFLATOR"
YES
Go to Step 2.
Substitute a known-
good SDM and re-
check.
Fig. for STEP 2
AIR BAG SYSTEM 9J-39
NO
1) Ignition switch OFF.
2) Replace passenger air
bag (inflator) module.
Repair short from "Y" or
"Y/R" wire circuit to power
circuit.
Special Tool
(A): 09932-76010