Options - Service; Fcs Options - Auto Save - Zeiss LSM 880 Operating Manual

ZEISS
Enable Laser Shutter Filter Wheel
If additional shutters (before the HeNe lasers and DSSP lasers and a line suppression filter wheel for the
Argon laser) are available in the laser module, they can be activated by checking the Enable laser
shutter filter wheel check box.
In this case, if the HeNe and DSSP filters are not used, a shutter will be placed in front of them; a line
selection filter will be used for the laser line activated for the Argon laser.
If activating more than two lines of the Argon laser, no line selection filter will be used.
This function is recommended when measuring close (within 0.2 µm) to the cover slip glass to
suppress any residual excitation light.
Fig. 588 FCS Options, Auto Save
Only .fcs and hence ANSI format files are saved in this directory. .raw data files are still saved in the
directory specified under Save raw data during measurement. However, if the Auto Save
option is active, temporary raw data files will be saved permanently and not only temporarily and
will be available if a software failure occurs. The FileName entry indicates that .fcs files will be
saved. This entry cannot be changed.
Fig. 589 Options, Service
418
CHAPTER 1 - SYSTEM OPERATION
Left Tool Area and Hardware Control Tools
000000-2071-464
5.5.6.3 FCS Options – Auto Save
The Auto Save panel (Fig. 588) enables you to
instruct the program
automatically and
measurement process. All data recorded until a for
example a software failure will be available this
way. This function
performing long measurements. If the Auto Save
check box is ticked you can specify the directory in
the Directory selection box, to which the
measurement should be saved.
5.5.7 Options – Service
Only for service use.
LSM 880
to save the results
continuously during
is recommended
10/2014 V_01
the
when