Zeiss LSM 880 Operating Manual page 288

ZEISS
For fitting to a PCH model the upper graph (Fig. 376) shows the PCH Fit diagram curves (frequency
against count rate per bin) with the overlaid fit graph. If an experiment is loaded for which no fit has
been conducted yet, only the measured curve is shown and no fit curve. The Fit deviation diagram will
be empty.
The Line width pull down menu allows to select the line width for the selected graph.
Fig. 376 Fit diagram panel for PCH analysis
The Zoom function of the Fit diagrams can be used to display certain diagram areas of interest in an
enlarged form:
• Use the left mouse button to click on the margin of an area of interest in the diagram, keep the
mouse button pressed and draw a rectangular above the area of interest in any required direction. On
release of the mouse button, the selected area is displayed in an enlarged form in the diagram. The
scaling of axis is matched automatically.
The context menu can be used to reset the zoom to its original value, copy the data, and adjust the
display.
282
CHAPTER 1 - SYSTEM OPERATION
Left Tool Area and Hardware Control Tools
000000-2071-464
LSM 880
10/2014 V_01