Fit - Zeiss LSM 880 Operating Manual

LSM 880
5.3.21.8

Fit

• Click on the Fit tab to activate the Fit display mode (Fig. 375).
In general this menu allows you to work with already measured and probably also fitted correlation
curves. The intention is to have the possibility of performing other fit using different fitting parameters if
the automatic fit did not yield optimal results.
The panel is divided in Diagrams, Result Table, Model Field and Fit action buttons.
(1) Diagrams
Fig. 375 Fit diagram panel for correlation analysis
For fitting to a correlation model the upper graph (Fig. 375) shows the Correlation G(t) Fit diagram
(correlation plotted versus the correlation time) with the overlaid fit graph. It also displays the fit range
defined by the red (start value) and the blue (end value) bars. The lower Fit deviation curve depicts the
fit residuals. If an experiment is loaded for which no fit has been conducted yet, only the measured
Correlation G(t) curve is shown and no overlaid fit curve. The Fit deviation diagram will be empty.
10/2014 V_01
CHAPTER 1 - SYSTEM OPERATION
Left Tool Area and Hardware Control Tools
000000-2071-464
ZEISS
281