Pinholes Section Panel - Zeiss LSM 880 Operating Manual

LSM 880
5.5.1.1

Pinholes Section Panel

The Pinholes Section panel has the following options:
Description field
Diameter [µm] slider
Position X Vis [µm] slider
Position Y Vis [µm] slider
Position X InVis [µm] slider
Position Y InVis [µm] slider
Stored Pos button
Adjustment: Adjust
Automatically button
Fast Adjust Mode check box:
No further software function can be activated and executed while automatic pinhole adjustment is
running.
10/2014 V_01
CHAPTER 1 - SYSTEM OPERATION
Left Tool Area and Hardware Control Tools
Display of the relevant active channel.
Setting of diameter, X-, Y- and Z-position of the pinhole in relation to
the beam path (Z-position can be set only for PH1) using the slider or
arrow buttons
Status display for setting procedure: green for ready and red for busy.
Pinhole setting is reset to the position last stored.
Automatic pinhole adjustment (not available in some systems).
If this check box is activated, the pinhole adjustment is only performed
in a limited area. Used for readjustment (not available in some
systems).
000000-2071-464
ZEISS
397