Zeiss LSM 880 Operating Manual page 506

ZEISS Center Screen Area / Image Containers - Display and Image Analysis
Tools in the Unmixing - Extract View Options Control Block:
These tools (Unmixing – Extract) are only available for Lambda stacks on an LSM 710 and LSM 780
system with 34 channel Quasar detector. Hence, they are not available for LSM 700 or LSM 7 LIVE
Hardware (tool tab grayed).
Button:
Slider:
channels button
button
500
CHAPTER 1 - SYSTEM OPERATION
Selection of a wavelength range (use the sliders) that will be assigned to
a channel. This assignment can be used for scanning (when Apply to
Hardware is pressed, see below) and /or for extracting a single or
multichannel image from the Lambda stack (when Extract Channels is
pressed). Clicking on the color box in the channel button opens the
color selection list and a LUT can be assigned to this channel.
Add or reduce the number of channels displayed and available for
assignment. Up to 8 channels labelled after the assigned LUT are
available.
Sum signals from selected detector elements
Mean signals from selected detector elements
Autoscaling of output channels (individually)
Generates a new image or multicolor images based on the settings
made in the channels. Two or more Lambda channels are binned to
form the channels 1 ... 8. The generated image is displayed in a new
Image Display window and is no longer a Lambda stack.
Sets the QUASAR detector parameters to match the previously defined
spectral ranges / channels. For the used in binning mode as specified in
the settings ChS1, ChS2, ChS3 ... ChS8. See Single Track and Multi
Track in Config Control for the effect of the action. The Lambda
stack setting is not affected by this action.
000000-2071-464
LSM 880
10/2014 V_01