Zeiss LSM 880 Operating Manual page 365

LSM 880
When the Save Default button is pressed, the
present coefficients will be stored and can be
recalled by pressing the Restore default button,
which becomes active once the Save default
button was pressed once.
If the Input 2 check box remains inactive, the image
selected for Input image 2 is not considered for
alignment. If the Input 2 check box is ticked, than the
channels of Input image 2 are aligned to the
corresponding channels of the Input image that is to
those channels at corresponding positions in the list.
It is the responsibility of the user to align only images of
the same dimensions and channels of the same format. If
images will have different dimensions, for example a raw
SIM Z-Stack and a raw PALM time the system will give no
warning message telling the user that the images do not
match (Fig. 512). It will load both images and aligns the
channels according to their position as long as there are
matching channels.
If no Input image was selected and only an Input
image 2, no alignment will be performed.
Loaded images cannot be unloaded but replaced
by other images in selecting the respective image
in the image container and then pressing the
Select button for Input image or Input image 2.
If the Fit check box is not ticked a second table, the
assignment table will be displayed below the
coefficient table (Fig. 513). In this case the selected
image will not be fitted directly, but a loaded alignment
will be performed on the image. Columns in the
coefficient and assignment tables can be expanded by
dragging the borders of the columns.
The coefficient table in this case has to be loaded from
a .bin file by pressing the Load button or is still available
from a previous alignment or obtained by pressing the
Restore Default button, if values have been previously
restored by pressing the Save default button. In any
case, the listed coefficients (no matter what Alignment
mode is associated) will be applied to the selected
image. If the Input 2 check box is inactive, this will be
the image selected for Input image. If the Input 2
check box will be ticked, it will be the image selected for
Input image 2.
10/2014 V_01
CHAPTER 1 - SYSTEM OPERATION
Left Tool Area and Hardware Control Tools
000000-2071-464
Fig. 512 Two images mismatched in
their dimensions (Z-Stack SIM
raw and time-series PALM)
images loaded
Fig. 513 Coefficient table and
assignment table
ZEISS
359