Action Buttons For Fcs - Zeiss LSM 880 Operating Manual

LSM 880
5.3.13

Action Buttons for FCS

The Action buttons
measurements and to adjust the measurement
conditions. The following buttons are available
(Fig. 333):
− New: opens up a new Image FCS Diagram
within a container.
− Count rate: opens the Count rate window.
− xyz-Scan: triggers a one dimensional (x, y, z)
or two dimensional (xy, xz, yz) scan.
− Snap: Starts a single measurement at the first (Sample Carrier) or highlighted (LSM Image) position.
− Start Experiment: Starts sequential measurements on all marked or highlighted positions.
− Stop: Ends or interrupts the current measurement (Appears only when a measurement is actively
running and replaces than the Start Experiment and the Snap buttons simultaneously.
Scans and measurements are performed according to the settings and methods defined in the FCS
tools.
Above and below the Action buttons the Method tool and Activation tab areas are available.
Besides the action button the Method tool allows to save, load and delete methods. The active tab area
allows some of the tabs to be activated by checking the corresponding boxes.
10/2014 V_01
CHAPTER 1 - SYSTEM OPERATION
Left Tool Area and Hardware Control Tools
are used to trigger
000000-2071-464
Fig. 333 Action buttons
ZEISS
249