Series - Zeiss LSM 880 Operating Manual

LSM 880 Center Screen Area / Image Containers - Display and Image Analysis
6.9.9

Series

The Series tab (Fig. 654) displays the Render
Series control panel. This panel allows settings for
the axis to be used for rotation of the 3D
reconstructed images. This feature is applicable to
all render modes available in 3D VisArt.
There are four different modes for producing
render series (see Fig. 656).
Depending on the activated mode, directly set the
parameters for animation in the Render Series
window and the position of the 3D image in the
Image Display window (zoom, rotation axes,
rendering parameters).
Click on Apply to start the animation
The animation is performed in a separate Image
Display window, which permits the animation to
be saved afterwards.
(1) Turn around X and Turn around Y mode
In this mode, the image is turned around the X-axis or the Y-axis exclusively.
The values for Number of Views, Difference Angle and First Angle can be selected accordingly).
(2) Start and End mode
In the Start and End mode, the image is recon-
structed between a start position and an end
position.
The rotation angles for X, Y and Z and the distance
(zoom) can be determined using the sliders.
The value for Total frames can be varied. The
frames are distributed equally between the start
and end points (Fig. 657).
10/2014 V_01
CHAPTER 1 - SYSTEM OPERATION
Fig. 654
Fig. 655
Fig. 656
Fig. 657
000000-2071-464
Series tab
Render Series window
(e.g. Turn around X mode)
Render Series modes
Start panel in the Render View
control block
ZEISS
463