Model Functionalities - Zeiss LSM 880 Operating Manual

LSM 880 Center Screen Area / Image Containers - Display and Image Analysis
6.19.6

Model Functionalities

Activate Model under the RICS view. The Model options will be displayed in the View control window
(Fig. 736).
Fig. 736 Fit control window
With the Model pull down menu you can select a
saved pre-defined model from the list. You can
rename a created or changed model by typing in a
new name in the display box. If the Ok button is
pressed, the model will be saved under the new
name (Fig. 737). If the model name was not
changed, you will be prompted to acknowledge to
overwrite the old existing one in the Save Model
Warning menu (Fig. 738). Press Yes to overwrite,
No to keep the old model.
Type in a name in the Model name display box
and press Ok, if you want to save the model, or
press Cancel without saving. You can delete a
model by pressing the Cross button. You will be
prompted to acknowledge the action within the
popped up Delete Model menu (Fig. 739). Press
Yes to delete, No if the model should be kept.
Below the Model pull down box the available
terms to assemble a model are listed. If you want
to take a term
corresponding box. Four terms are available:
Scanning G , Offset d, Amplitude A and
s
Translation G
. The assembled model will be
d
displayed in the spatial correlation G(ξ,ψ) display
area.
10/2014 V_01
CHAPTER 1 - SYSTEM OPERATION
into account, check
000000-2071-464
Fig. 737 Model Save menu
Fig. 738 Save Model Warning menu
the
Fig. 739 Delete Model menu
ZEISS
523