Zeiss LSM 880 Operating Manual page 182

ZEISS
Start Experiment
action button
Stop action button
Stop current step
action button
Method drop down
menu
Tool activation area
check boxes
Laser tool
[Setup]
Light Path tool
[Setup]
Acquisition tool
[Setup]
Fit tool
[Setup]
Correlator tool
[Setup]
Stage tool
[Navigation]
Sample Carrier tool
[Navigation]
Focus tool
[Navigation]
Incubator tool
[Navigation]
Time Series tool
[Multidimensional
Acquisition]
Positions tool
[Multidimensional
Acquisition]
176
CHAPTER 1 - SYSTEM OPERATION
Left Tool Area and Hardware Control Tools
Triggers measurements according to the settings at all defined
positions.
Will end an active measurement. Data will be available to store
up to the end point.
Note this button only appears in the place of the Snap action
button if this or the Start Experiment button was pressed and
an active measurement was triggered.
Will end an active measurement. Data will be available to store
up to the end point. Note that this button replaces the Start
Experiment button, if the latter was pressed.
Store, delete and load pre-defined methods to be used in the
measurements; enter experimental info and document data
Activate certain toolbars in the display
Control to switch on / off lasers and check their status
Define, store, delete and load predefined light paths; select laser
lines and power; adjust pinhole
Set measurement times, channel color, pinhole size, pupil filing
factor (if available)
Define fit models and select model for data analysis
Set up correlation parameters to be used in the experiment
Control movement of motorized stage
Define, save, load and orientate sample carrier
Define and control focus position
Define and control environmental conditions
Set kinetics (only available, if Time Series box is checked)
Define and orient a sample carrier in x, y and z.; set
measurement positions (only available, if the Position box is
checked
000000-2071-464
LSM 880
10/2014 V_01