Setup Manager - Laser - Zeiss LSM 880 Operating Manual

LSM 880
5.2.5 Setup Manager – Laser
Open (and close) the Laser tool (Fig. 86) (only
available when the Show all tools check box is
ticked) by clicking the Laser tab in the Setup
Manager tool group.
Lasers are listed with their Laser name, their Laser
lines (nm) and their Power state. Lasers available
for ELYRA have the extension (Elyra) in their
name. Select the power state from the power state
switch box. It shows the state of the laser: On, Off
or Standby. Standby mode is available for some
lasers. To activate a laser select On or Standby to
switch the laser on for immediate use or for warm
up, respectively. A laser that is in Standby will
automatically go to On state, when in use and go
back to Standby, when not in useThe Argon laser
and Ti:Sa lasers are not set to Standby when not in
use, they have to be set to Standby deliberately.
Lasers with no switch button, like the HeNe laser,
will be switched on automatically after software
start.
The Laser Properties panel displays the current
wavelength, status, mode (ps or cw if applicable),
tube current (Argon laser) and power (Argon and
Ti:Sa laser).
When exiting the Software, the Laser Off panel
will be displayed - unless the checkbox Lasers off
on exit in Maintain / Systems Options /
Hardware is not ticked - showing the current
power state of the lasers (Fig. 87). The user has the
possibility to manually switch off still active lasers
before the software closes. In case the status ON is
not changed, lasers are set into standby mode if
applicable. Lasers without power status are
switched off. The shutter of Ti:Sa lasers will always
be closed when the software is shut down.
After switching on the lasers in the laser
control window and their status is
displayed as ready (On) the system can be
used for
quantitative imaging it is recommended
to let the system warm up for up to 2
hours.
Please bear in mind that a cooling phase
of at least 5 minutes is required between
switching off the laser via the software
and switching off the entire system via
the power remote switch.
10/2014 V_01
CHAPTER 1 - SYSTEM OPERATION
Left Tool Area and Hardware Control Tools
imaging. However,
000000-2071-464
Fig. 86 Laser tool
Fig. 87 Laser Off panel
for
ZEISS
77