Map Filter - Zeiss LSM 880 Operating Manual

LSM 880
5.4.21.4

Map Filter

• Activate Map filter in the ICS tool. The Map
filter menu will appear (Fig. 545).
• To select an image highlight the image in the
Image container and press the Select button.
This will be your Input image map.
As an output image map an image map with the
selected filters applied is computed and the result
filtered image maps will be opened as a new
image maps in the container.
The way of filters to be applied can be selected in
the Filter maps menu, which can be opened by
the arrow, by
[Std.Dev./value] and the Mean value variance
check boxes.
Note that both filters can be applied
together by checking both boxes.
• Thresholds for the filters can be entered in the
corresponding input boxes by typing or by using
the arrows. Pixels with values exceeding the
threshold will be displayed in black and will be
discarded for the scaling of the map.
• You can define if all maps should be filtered by
pressing All button in the available filter display
area.
• If you want to apply filtering only to a specific
map (Number of particles, its standard
deviation Std.Dev.; Diffusion coeff. [µm x
µm /s], its standard deviation Std.Dev. and Χ
the Filter all maps box must not be ticked and
the corresponding map button pressed, which
is indicated by highlighting in blue.
Note that filtering is never applied to the Χ
map, even if it was selected.
10/2014 V_01
CHAPTER 1 - SYSTEM OPERATION
Left Tool Area and Hardware Control Tools
Ratio
checking the
000000-2071-464
2
)
2
Fig. 545 Processing – ICS Map filter
ZEISS
387