Zeiss LSM 880 Operating Manual page 407

LSM 880
Automatic pinhole adjustment:
The automatic adjustment allows the pinholes to
be used with any combination of beam splitters
and more than one active channel.
Please do
manipulations
pinhole adjustment is running (status
display is red - busy).
• Click
on the
Automatically button.
Requirements
− The
window will then appear.
• Meet
the requirements
Requirements for
(Fig. 559). Press Cancel to abort the automatic
pinhole adjustment. Press the OK button to
proceed.
Pinhole adjustment
−
automatically and the Scan window will
appear (see
procedure takes approx. 3 min.
− The determined
automatically and will be available for all
further examinations
configuration.
A change of the pinhole diameter made
manually in the Pinholes section panel
will update the pinhole diameter in the
Channels tool and vice versa.
Pinhole adjustment should be done on a
regular basis (monthly, depending on
system usage).
10/2014 V_01
CHAPTER 1 - SYSTEM OPERATION
Left Tool Area and Hardware Control Tools
not make any program
while the automatic
Adjustment Adjust
for Adjustment
listed in
Adjustment
window
will then
Fig. 560). The adjusting
data are
using the
000000-2071-464
the
run
Fig. 559
stored
same
Fig. 560
Requirements for
window
Pinhole adjustment scan window
ZEISS
Adjustment
401