Zeiss LSM 880 Operating Manual page 166

ZEISS
Fig. 226 Start Mode drop down menu– Trigger selected
Fig. 227 Start Mode drop down menu – Time selected
Fig. 228 Start – time series in process
Fig. 229 Start – time series interrupted
160
CHAPTER 1 - SYSTEM OPERATION
Left Tool Area and Hardware Control Tools
000000-2071-464
If Trigger is selected the Trigger In
drop down menu becomes available
(Fig. 226) from which up to 4 triggers
can be selected. After pressing Start
Experiment button the system will
display the message Waiting for
Trigger and starts acquisition once it
received the trigger in signal.
If Time is selected the hh, min and
sec input boxes become available
(Fig. 227), in which the hours, minutes
and seconds can be edited. After
pressing Start Experiment button the
system will display
Waiting for Start Time and starts
acquisition after the defined computer
time has been elapsed.
If the Pre-Scan checkbox is ticked
(Fig. 228) a continuous
performed when
Experiment button, but no image
series is acquired until you hit the Go
button, which becomes visible next to
the Pause button in the lower part of
the control window. Once the Go
button was pressed it will disappear.
When Pressing the Pause button,
which becomes active after Start
Experiment was pressed, the time
series is interrupted and the current
scan is finished. The labeling of the
button changes to Resume (Fig. 229)
and if the Resume button is pressed
the time series
continued.
It is possible to send a Trigger Out
signal with the start of the times series.
The Trigger Out drop down menu
allows defining up to 4 trigger out
signals.
LSM 880
the message
scan is
Start
clicking
is immediately
10/2014 V_01