Show Running-Config Monitor Session - Dell S4810 Reference Manual

Version
8.3.19.0
Version 8.3.7.0
Version 8.3.11.1
Version 8.1.1.0
Version 7.7.1.0
Version 7.5.1.0
Version 7.4.1.0
Example
Dell#show monitor session
IP
---------
A
A
36.36.36.1
Related monitor session
Commands

show running-config monitor session

Display the running configuration of all monitor sessions or a specific session.
S4810
Syntax
show running-config monitor session {session-ID}
To display the running configuration for all monitor sessions, use the show
running-config monitor session command.
Parameters
session-ID
Defaults none
Command
•
Modes
•
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
Port Monitoring
Introduced on the S4820T.
Introduced on the S4810.
Introduced on the Z9000.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
SessID Source
Dest IP
------ ------
--------
1 Te 0/1
N/A
2 Po 128
N/A
3 Te 0/2
72.72.72.2
— creates a session for monitoring.
(OPTIONAL) Enter a session identification number. The range
from 0 to 65535.
EXEC
EXEC Privilege
Destination
-----------
Te 0/4
remote-vlan 100
remote-ip
Dir Mode Source
--- ----
both Port N/
tx Port N/
rx Port
1313