Connecting The Chassis To The Network; Assign An Ip Address To A Vlan - Dell Force10 S60 Quick Start Manual

Use the untagged command to move untagged interfaces from the Default
VLAN to another VLAN:
Step Task
Access the
1
INTERFACE VLAN
mode of the VLAN to
which you want to
assign the interface.
Configure an interface
2
as untagged. This
command is available
only in VLAN
interfaces.

Assign an IP address to a VLAN

NOTE: An IP address cannot be assigned to the Default VLAN, which, by default,
is VLAN 1. To assign another VLAN ID to the Default VLAN, use the default
vlan-id vlan-id command.
Task
Configure an IP address and mask on
the interface.

Connecting the Chassis to the Network

Once you have completed the hardware installation and software configuration,
you can connect to your company network by following your company's cabling
requirements.
24
Installing the Software
Command Syntax
interface vlan vlan-id
untagged interface
Command Syntax
ip address ip-address
mask [secondary]
Command Mode
CONFIGURATION
INTERFACE
Command Mode
INTERFACE