Auerswald COMpact 3000 analog Operating Manual page 435
Hide thumbs
Also See for COMpact 3000 analog:
- Installation, operation and configuration instructions (608 pages) ,
- Quick start instructions (2 pages)
Table of Contents
Advertisement
• Delete non-numeric characters: Deletes all non-numeric characters. Example: The
address 05306unknown@sipgate.de becomes 05306 after this rule is applied.
• Prefix the number with 00: Places 00 before the number. Example: The number
4953069200700 becomes 004953069200700 after this rule is applied.
• Replace the country code at the beginning of the number with 0: Replaces the country
prefix (e.g., 0049) at the beginning of the number with a 0. The country prefix must be
entered in the PBX (CONFIGURATION > External phone numbers > Location).
Example: The number 004953069200700 becomes 053069200700 after this rule is
applied.
• Prefix the number with: Places 0 before the number. Example: The number 53069200700
becomes 053069200700 after this rule is applied.
• "unknown" is changed to "number unknown": The string 05306unknown is treated as
an unknown telephone number in the system when these rules are applied.
Configuration can be carried out as follows:
• Separately for VoIP providers
• Via the configuration manager
Requirements:
– External VoIP channel (COMpact 3000 VoIP or VoIP channels purchased and activated in
the Upgrade Center)
– Configuration manager, opened with sufficient authorisation
1. Check the format in which the telephone numbers issued by the provider are trans-
mitted and displayed in the call data list (USER DATA > Call data list).
2. Determine which rules need to be applied for converting a telephone number and in
what sequence so that these telephone numbers can be used for callbacks.
3. Open the page CONFIGURATION > Voice over IP (VoIP) > VoIP provider.
4. Click
in the line of the corresponding VoIP provider.
The Provider configuration opens.
5. Open the page Provider configuration > Conversion of incoming VoIP telephone
numbers.
6. In the first list field Rules in sequence of execution, select the first rule.
7. In the following list field Rules in sequence of execution, select the next rule.
8. Repeat Step 7 until all of the required rules are displayed in the desired sequence.
COMpact 3000 analog/ISDN/VoIP - Firmware V4.0 - Operating Manual V06 12/2020
Configuring the Conversion of Incoming VoIP Telephone Numbers
Settings
VoIP
435
Advertisement
Table of Contents
