Switching S Bus Monitoring On/Off - Auerswald COMpact 3000 analog Operating Manual

4. Select one of the following options:
Point-to-Multipoint connection: ISDN Point-to-Multipoint connection (PTMP)
PBX connection: ISDN Point-to-Point connection (PTP)
Further steps:
– Save your settings before you leave the page.
Switching S Bus Monitoring On/Off
0
If S bus monitoring is enabled, a continuous activation of the shift 1 for the separate external
0
S busses is possible.
0
The PBX checks whether the shift 1 from the network provider activated is or idle. When a
function is enabled, the activation of this shift is requested as soon as the shift 1 from the
network provider is put into idle mode.
Note: The S
dial tone indicates operational readiness.
If this function, e.g., causes too many problems for exchange lines outside of Germany, it can
be disabled.
Switching this on/off can be done as follows:
• Via the configuration manager
Requirements:
– External S port (only COMpact 3000 ISDN or COMpact ISDN module available as an option)
0
– Configuration manager, opened with sufficient authorisation
– Configured prefixes (country prefix and local area code)
1. Open the page CONFIGURATION > External numbers.
2. In the list field at the top, select the ISDN connection in question.
A page opens for configuring the ISDN connection.
3. Open the page ISDN connection > Kind of connection.
4. Select or clear the S0 bus monitoring check box.
COMpact 3000 analog/ISDN/VoIP - Firmware V4.0 - Operating Manual V06 12/2020
bus monitoring prevents, e.g., delay times before the external
0
Settings
ISDN Connection
Switching S Bus Monitoring On/Off
0
399