Switching Pound Sign Transmission On/Off - Auerswald COMpact 3000 analog Operating Manual

The configuration can be made as follows:
• Via the configuration manager
Requirements:
– External analogue port (only COMpact 3000 analogue)
– Configuration manager, opened with sufficient authorisation
– Expert view (click
– Configured prefixes (country prefix and local area code)
1. Open the page CONFIGURATION > External numbers.
2. In the list field at the top, select the analogue connection.
A page opens for configuring the analogue connection.
3. Open the page Analogue connection > Expert configuration.
4. In the Delay time after last digit dialled entry field under Start of call (outgoing
calls), enter a value. The following entries are possible:
3 to 30: After 3 to 30 seconds of no dialling of a digit, the PBX detects the end
of dialling.
Note:
Since the PBX does not pass on the last digit to the central office until after
the configured time has elapsed, select a time that is as short as possible.
Approximately 3 seconds is a good default value for manual entries.
Further steps:
– Save your settings before you leave the page.

Switching Pound Sign Transmission On/Off

If pound sign transmission is enabled, the PBX transmits the pound sign (#) to the central office
after a telephone number has been dialled.
Switching this on/off can be done as follows:
• Via the configuration manager
COMpact 3000 analog/ISDN/VoIP - Firmware V4.0 - Operating Manual V06 12/2020
)
Analogue Connection
Switching Pound Sign Transmission On/Off
Settings
383