Configuring Subscribers For Lcr - Auerswald COMpact 3000 analog Operating Manual

Functions
LCR

Configuring Subscribers for LCR

4. Select the LCR option button under Special connection functions.
Enables the automatic LCR on the connection.
Disables the automatic LCR on the connection.
Note: If the network provider does not support LCR, the LCR must be
disabled (
Further steps:
– Save your settings before you leave the page.
Configuring Subscribers for LCR
Note:
LCR for Call Through calls is switched on/off on the page FUNCTIONS >
Call Through under Settings.
Manual LCR by dialling a preceding provider area code is always possible if
the network provider supports call-by-call.
The configuration can be made as follows:
• Via the configuration manager
Requirements:
– Configuration manager, opened with sufficient authorisation
1. Open the page FUNCTIONS > Least Cost Routing > LCR subscribers.
2. Select or clear the check box next to the corresponding subscribers.
Enables automatic LCR for the subscriber.
Disables automatic LCR for the subscriber.
Further steps:
– Save your settings before you leave the page.
258
No).
COMpact 3000 analog/ISDN/VoIP - Firmware V4.0 - Operating Manual V06 12/2020