Switching Ecm (Error Correction Mode) For Fax Transmission On/Off - Auerswald COMpact 3000 analog Operating Manual

Note:
If the function Close dialogue automatically after successful transfer has
been enabled in the printer driver before the fax has been transferred
successfully, this step will not be applicable.
If you want to cancel the transfer of a fax because, for example, you entered
the wrong number for the fax recipient, you can delete the fax message under
USER DATA > Messages + selection of the fax box in question in the list
field at the top. To do this, click the waste bin symbol in front of the fax
message to be deleted and then, click the tick symbol. The transfer of this fax
message is cancelled.

Switching ECM (Error Correction Mode) for Fax Transmission On/Off

If ECM is enabled, transmission errors during transmission (e. g. caused by bad cables) are
adjusted, as far as the receiver also supports ECM.
When many transmission errors occur (e. g. transoceanic cables or VoIP connections with
many package losses) the sending cannot be transmitted because the fax devices cancel the
transmission due to too many repetitions. In such cases it might be better to disable ECM.
Without ECM transmission errors are displayed as defective points or lines.
Switching this on/off can be done as follows:
• Separately for fax boxes
• Via the configuration manager
Requirements:
– An SD card inserted in the SD card slot or a USB memory stick inserted in the USB port
– Configuration manager, opened with sufficient authorisation
1. Open the page FUNCTIONS > Voice mail/fax boxes > Boxes.
2. Click in the line of the corresponding fax box.
3. Select or clear the ECM (Error Correction Mode) check box under Fax trans-
mission.
Enables ECM (error correction mode).
Disables ECM (error correction mode).
COMpact 3000 analog/ISDN/VoIP - Firmware V4.0 - Operating Manual V06 12/2020
Switching ECM (Error Correction Mode) for Fax Transmission On/Off
Voice Mailboxes and Fax Boxes
Fax Box
183