Auerswald COMpact 3000 analog Operating Manual page 29

• ISDN telephones in compliance with the Euro ISDN Standard (DSS1)
• ISDN PC controller in compliance with the Euro ISDN Standard (DSS1)
Important: The power consumption of the end devices on a U
total a maximum of 2.5 W.
External S Port (only COMpact 3000 ISDN or COMpact ISDN module available as an
0
option)
The external S port is designed for the connection to an NT working according to the European
0
protocol DSS1 (Euro ISDN). It supports the following connection types:
• Basis access as a Point-to-Multipoint connection
• Basis access as a Point-to-Point connection
Furthermore, it is possible to connect to a digital GSM gateway.
External Analogue Port (only COMpact 3000 analogue)
The external analogue port is tested in compliance with the former TBR21 standard and
therefore suitable for connecting public analogue telephone networks across Europe. When
using the international system variant, the country in which the PBX is operated over an
analogue connection must be configured after the device has been put into operation.
Furthermore, it is possible to connect to an analogue GSM gateway.
Ethernet Port
For configuration/administration, the Ethernet port can be connected to a separate PC or to a
local network (LAN).
For a CTI solution (LAN-TAPI), the Ethernet port can be connected to a local network (CTI
server and CTI clients). This requires CTI software. We recommend the following software
manufacturers:
• ESTOS (www.estos.de)
• ilink (direct.ilink.de)
The following telephones connected to the PBX are supported by the LAN-TAPI:
• COMfortel 1200/1400/1600/2600 system telephones
Important:
To support the COMfortel 1600 and COMfortel 2600 system telephones, the
PBX needs a firmware version 4.0I and higher.
COMpact 3000 analog/ISDN/VoIP - Firmware V4.0 - Operating Manual V06 12/2020
Important Information
Product Details
port may
P0
29