Ending Conference Call - Auerswald COMpact 3000 analog Operating Manual

Telephoning
Conference Calls

Ending Conference Call

– To connect two external communication partners, the following is required: Authorization
Transfer of external calls to external assigned to the subscriber
During a conference call, proceed as described in the following.
1. Press the Flash key (when using a telephone with DTMF dialling) or the Query key
(when using an ISDN telephone).
2. Dial 4.
3. Hang up the receiver.
Both conference call partners are connected with each other.
Important: To use this function at ISDN telephones and system telephones,
the function must be supported via a function key or via the menu by the
respective telephone (optional, see manual for the telephone).
Ending Conference Call
Requirements:
– A conference call that you initiated yourself
During a conference call, proceed as described in the following.
• Hang up the receiver.
The conference call is disconnected completely.
126
COMpact 3000 analog/ISDN/VoIP - Firmware V4.0 - Operating Manual V06 12/2020