Transfer And Callback; Configuring Hook Flash Timing - Auerswald COMpact 3000 analog Operating Manual

Settings

Transfer and Callback

Configuring Hook Flash Timing

Transfer and Callback
The PBX requires specifications for the transfer and the callback option for external callers to
be executed as desired.
Configuring Hook Flash Timing
Hook flash timing enables the PBX to detect a flash signal from the subscriber in question.
For this to work, the hook flash timing must correspond with the time that is configured for the
flash signal on the analogue end device (see manual for the telephone).
Note:
DTMF telephones that execute various functions using the T-Net function
key/menu use a flash of 300 ms to do this. In order to also use these functions
on the PBX, the same time as the hook flash timing must be configured on
the PBX. Usually, there is an additional flash button available on this
telephone that must also be configured with this value (see manual for the
telephone).
Note that the PBX does not detect a receiver being hanged up until after hook
flash timing is finished.
The configuration can be made as follows:
• Separately for subscribers
• Via the configuration manager
Requirements:
– Configuration manager, opened with sufficient authorisation
– Expert view (click
– Analogue subscriber
1. Open the page PROPERTIES > Internal subscribers > Subscriber properties >
Analogue settings.
2. In the list field at the top, select the subscriber in question by his name or number.
3. In the Hook flash timing list field, select one of the following options:
502
)
COMpact 3000 analog/ISDN/VoIP - Firmware V4.0 - Operating Manual V06 12/2020