Auerswald COMpact 3000 analog Operating Manual page 207

2. Depending on the type of call forwarding desired, select or clear the one of the
following check boxes immediately or on busy or on no reply.
Enables the type of call forwarding in question.
Disables the type of call forwarding in question. (No other action is required.)
3. Enter the destination number in the Destination number entry field under the desired
type of call forwarding immediately, or on busy, or on no reply. The following
entries are possible:
Up to 20 digits
Exchange line access number + external phone number
Short-code numbers
Further steps:
– Save your settings before you leave the page.
Switching Call Forwarding Unconditional for External Numbers On/Off via an Internal
Telephone
Requirements:
– External analogue port (only COMpact 3000 analogue), external S
COMpact 3000 ISDN or COMpact ISDN module available as an option) or external VoIP
channel
– Authorization Controlling of the PBX via telephone assigned to the subscriber
– Subscriber authorisation for configuring features on the exchange line
1. Pick up the receiver.
2. Dial ##96.
3. Enter the telephone number to be rerouted. The following entries are possible:
External phone numbers
exchange access)
Note:
Telephone numbers to be rerouted are telephone numbers dialled by external
callers (prefix + PBX base number + DDI or prefix + MSN).
If the PBX only has one external connection and one telephone number has
been selected for number presentation, you can simplify call forwarding
configuration. If you configure call forwarding for external numbers for this
COMpact 3000 analog/ISDN/VoIP - Firmware V4.0 - Operating Manual V06 12/2020
Switching Call Forwarding for External Numbers On/Off
(independent of the configuration of the direct
Functions
Call Forwarding
port (only
0
207