Configuring Subscribers For The Charge Burden; Configuring The Time Limit For Initiating An External Call - Auerswald COMpact 3000 analog Operating Manual

Functions
Exchange Line Transfer

Configuring Subscribers for the Charge Burden

Configuring Subscribers for the Charge Burden
It must be defined which of the two subscribers should be billed the charges for a call.
The configuration can be made as follows:
• Via the configuration manager
Requirements:
– For executing the exchange line transfer: System telephone with configured function key for
the exchange line transfer
– Internal S port (only available on the optional COMpact S
0
module) or internal VoIP channels (COMpact 3000 VoIP or VoIP channels acquired in the
Upgrade Center and released)
– Configuration manager, opened with sufficient authorisation
– Expert view (click
1. Open the page FUNCTIONS > Transfer.
2. Select one of the following options in the Charge burden list field under Exchange
line transfer.
Transferring subscriber: The charges are billed to the transferring subscriber.
Requesting subscriber: The charges are billed to the requesting subscriber.
Further steps:
– Save your settings before you leave the page.

Configuring the Time Limit for Initiating an External Call

The time limit for initiating an external call indicates how many minutes the exchange line
access will persist at maximum if a call is not initiated successfully.
The configuration can be made as follows:
• Via the configuration manager
Requirements:
– For executing the exchange line transfer: System telephone with configured function key for
the exchange line transfer
200
)
COMpact 3000 analog/ISDN/VoIP - Firmware V4.0 - Operating Manual V06 12/2020
module or COMpact ISDN
0