Voip; Configuring Voip Channel Use - Auerswald COMpact 3000 analog Operating Manual

VoIP

In Internet telephony (VoIP, Voice over Internet Protocol), an Internet connection (for example,
DSL) is used for telephoning instead of an analogue or ISDN line. In this case, digital voice data
is sent as IP packets from one telephone to another. This functions the same way as the trans-
mission of a webpage over the Internet.
The transmission quality and the reliability of Voice over IP depends to a great extent on the
quality of the Internet connection used.

Configuring VoIP Channel Use

Configure how many currently existing external and internal VoIP channels are to be used.
Note:
A COMpact 3000 analogue/ISDN has two VoIP channels that can be
purchased and activated in the Upgrade Center in both the German and the
international PBX models. Each VoIP channel can be configured as internal
or external.
The COMpact 3000 VoIP provides two additional VoIP channels in the basic
model; one of these channels can be configured as a permanent external
VoIP channel.
Configuration can be carried out as follows:
• Via the configuration manager
Requirements:
– VoIP channels (COMpact 3000 VoIP or VoIP channels purchased and activated in the
Upgrade Center)
– Configuration manager, opened with sufficient authorisation
1. Open the page CONFIGURATION > Voice over IP (VoIP) > Settings.
Note: Configuration is also offered in the configuration wizard during quick
setup.
The available VoIP channels (Available VoIP channels) are displayed under Distri-
bution of the VoIP channels.
COMpact 3000 analog/ISDN/VoIP - Firmware V4.0 - Operating Manual V06 12/2020
Settings
VoIP
Configuring VoIP Channel Use
405