Switching Line Polarity Reversal Detection For End Of Call On/Off - Auerswald COMpact 3000 analog Operating Manual

Table of Contents

Advertisement

Switching this on/off can be done as follows:
• Via the configuration manager
Requirements:
– External analogue port (only COMpact 3000 analogue)
– Network provider support for the DTMF code D at the end of a call
– Configuration manager, opened with sufficient authorisation
– Expert view (click
– Configured prefixes (country prefix and local area code)
1. Open the page CONFIGURATION > External numbers.
2. In the list field at the top, select the analogue connection.
A page opens for configuring the analogue connection.
3. Open the page Analogue connection > Expert configuration.
4. Select or clear the DTMF code D check box under End of the call.
Enables DTMF code D detection.
Disables DTMF code D detection.
Further steps:
– Save your settings before you leave the page.

Switching Line Polarity Reversal Detection for End of Call On/Off

If line polarity reversal detection is enabled, the PBX network provider detects the polarity
reversal as a signal for the end of the call.
Switching this on/off can be done as follows:
• Via the configuration manager
Requirements:
– External analogue port (only COMpact 3000 analogue)
– Line polarity reversal support at the end of a call by the network provider
– Configuration manager, opened with sufficient authorisation
– Expert view (click
COMpact 3000 analog/ISDN/VoIP - Firmware V4.0 - Operating Manual V06 12/2020
)
)
Switching Line Polarity Reversal Detection for End of Call On/Off
Settings
Analogue Connection
391

Advertisement

Table of Contents
loading

This manual is also suitable for:

Compact 3000 isdnCompact 3000 voip

Table of Contents