Auerswald COMpact 3000 analog Operating Manual page 456

Settings
DECT System Telephones
Copying a Function Key Assignment into Other Mobile Handsets
Copying can be carried out as follows:
• Via the configuration manager
Requirements:
– Internal S port (only provided on the COMpact S
0
available as an option)
– Configuration manager, opened with sufficient authorisation
– Configured internal telephone numbers for the base station
– Assigned internal telephone numbers for the mobile handsets
1. Open the page CONFIGURATION > Internal numbers > ISDN subscribers.
2. Click DECT settings.
3. Open the page Copy COMfortel DECT 900.
4. In the list field at the top, select the mobile handset, whose function key assignment
should be copied based on its name/number.
5. Select or clear the corresponding Copy function check box under Copy function
key.
Selects the assignment for copying.
Does not select the assignment for copying.
6. Under Destination, select or clear the check box next to the internal telephone
numbers for the mobile handsets into which the selected function key assignments
should be copied.
Enables the mobile handset as the destination.
Disables the mobile handset as the destination.
7. Click Copy.
Note: The PBX begins to distribute the data to the mobile handsets in
question. If a mobile handset is currently not ready for the data transfer
(disabled, out of range or busy with a call), the PBX makes an attempt with
the next mobile handset after a few minutes until all of the data is distributed.
During the data transfer (duration: up to two minutes), the mobile handset is
not available and "Copying from PBX" is shown on the display.
456
module or COMpact ISDN module
0
COMpact 3000 analog/ISDN/VoIP - Firmware V4.0 - Operating Manual V06 12/2020