Configuring A Ringer Rhythm For External Calls Via The Point-To-Point Connection - Auerswald COMpact 3000 analog Operating Manual

Further steps:
– Save your settings before you leave the page.
Configuring a Ringer Rhythm for External Calls via the Point-to-Point
Connection
The ringtone indicates which tone sequence is being used to signal external calls, made on the
telephone number assigned to the point-to-point connection, to the internal PBX subscribers.
Note:
Signaling is carried out by analogue devices as described.
ISDN devices generate their own call tone/ringtone. For more information,
refer to the description of your ISDN end device.
The configuration can be made as follows:
• Via the configuration manager
Requirements:
– External S port (only COMpact 3000 ISDN or COMpact ISDN module available as an option)
0
or/and VoIP account in the connection type point-to-point connection
– Configuration manager, opened with sufficient authorisation
– Configured prefixes (country prefix and local area code)
1. Open the page CONFIGURATION > External numbers.
2. In the list field at the top, select the connection in question.
A page opens for configuring the connection in question.
3. Open one of the following pages:
• ISDN connection > Telephone numbers
• VoIP connection > Telephone numbers
Note: The configuration is also provided during the quick configuration using
the configuration wizard.
4. Select one of the following options in the Ringtone list field.
COMpact 3000 analog/ISDN/VoIP - Firmware V4.0 - Operating Manual V06 12/2020

Configuring a Ringer Rhythm for External Calls via the Point-to-Point Connection

Settings
Ringer Rhythms
489